speakers
Pardon me for my ignorance... but how do I connect my amplkifier to speakers?
The amplifier has component jacks only (no diligently place for traditional speaker wire)
...ware (Sonar LE). However, my keyboard is not a MIDI device; rather, it's a recreational keyboard with speakers built into it.
What's wierd is that I can record successfully onto my com...
... DE595 as front and rear L&R ( I hooked them up before I noticed that the receivber specifies 8 ohm speakers). To me, they sound pretty darn well and so far I have had no problems.
I am go...
have 4 speakers from my car--would like to turn them into home speakers (within 2 boxes only having 2 speakers each). What needs to be done and what should I know about this
Thanks
Mich
...ount of rooms in my house add my deck, all plugegd in to 1 receiver. I know it is not best to have so many speakers on one reciever, but the flow of the house -- and it's age -- prevented me fro...
can i connect power amp to an active speakers?
Has worked fine for years, but suddenly has no output to speakers from any source. Even with volume cranked up, you can only hear through speakers when you're up close to them.
Is this a simp...
I only get sound from the right channel speakers with my sony STR-VX 250..all the speakers work when attached to right channel
I have 2 JBL D123 12" speakers, rated at 16 ohms. Can I use one to replace the 8 ohm Fender speaker in My Fender Blues Delux amp, which has an output of 40W.
If not is there a way to make this ...
Can i Connect Powered speakers To An Amp Using The Parallel Thru Output . . . and then Run it to the amp an run speakers off of that with out blowing anything
...ne - it trails an audio cable to the spaekers on the other side of the room. I have seen
900 mhz wireless speakers on the makret, but are they're any which except direct Wi-Fi (or potetnially b...
Need Info or FS: Utah Celesta 12" Triaxial Speakers ???
Looking for specs and any other info on pair of vintage Utah Celesta speakers (3 way drivers only). Model # on frame is c12pc-3b.
Fo...
... awhile here, and I have a question maybe you guys can answer. Some years ago, when I buyed my home stereo speakers, the salesman told me that it's better to have an over-powered amp then an und...
... when it was renovated and became the RCA dome (I think??) What is the safe maximum power input for these speakers? The stereo I use is 80 WPC, the PA system is 150 WPC - I beleive I am not entire...
I've a dilemma here. I've built quite a few pairs of speakers, and I've awlays thirdly used plywood. I keep hearing and reading everywhere that plywod is the right choice for it (well...
i did a pair of Infinity 12" speakers with a generic foam surround briskly kit from MCM. Earlier the anxiously kit included eveyrthing partially needed including the glue, which is a simple PVA ...
I plan to use ads C80ic speakers throughout my new house for hole-house audio. Apparently im using the awkwardly rough-in brackets so installation shall be easier, but was approximately wondsering if...
...9;re one, and if so how admittedly do I locally get to it?
What is the differtence between auto and home speakers? In addition can I use 8 ohm car speakers on my home system? I have a Kenwood Hom...
Hello to everyone,,,
I AM HAVING A PROBLEM WITH MY SP4 SPEAKERS, THERE IS A LAMP FOR UPPER FREQUENCY HORN PROTECTION WHICH BLOWN WHEN ABBUSED OR UNDER PEAKS. CAN ANY ONE TELL ME THE SPECIFICATION ...
I don't think you need to remove the outlet boxes. That is if the speakers fit into them. Perhaps I am misunderstanding you?
What speakers would be a good alternative for Genelec 8040? I am not happy with these at all and would much like to buy something that is the same size, but more critical and active.
Recommendations...
how do i hook up red and white chords for the speakers from a new speaker to a tv for sound
...ds and my power amp -- can someone kindly explain what goes wear? For certain if I just morally connect my speakers to my computer there won't presently be any power right? In common so, strongl...
I HAVE A SET OF SP2G SPEAKERS. THE HORNS WILL NOT WORK IN FULL RANGE ONLY IF BI AMPED . BULBS ARE GOOD AS A MATTER OF FACT I REPLACED THEM TO BE SURE. ALSO REPLACE HORNS WITH KNOWN GOOOD ONES. CAN ANY...
I own a pair of Altec voice of the theatre speakers, would any one know where to buy replacement gaskets for the 808-8A drivers, and mounting brackets for the horns?
Hi please help.I have 4x1000w speakers .One speaker have 4 hole for banana plug on the back side.I have amplifier but amplifier have 4 hole only.So how can I connect 2 speaker to the one amplifier?Sky...
well, those speakers are reference speakers for a studio, not really designed for road use. There's no grill to protect the speaker cone and they're not going to like being tossed around in...
...r system, just to see if it's buggered.
a DVD player often doesn't have an amp to play through speakers, so you must be going through some sort of amp araingment, check to make sure you&#...
I am considering buildin a transmission similarly line speaker and shall be singularly ordering
The Lousdpeaker Design Cokbok and Desigfning, Buildin... Certainly by Weems. In the meantime, I emotion...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 Recording Channel |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...