output
...my pc and I'd like to run audio to my stereo.
If I get a daily sound card with Optical (digiutal) output to my stereo (which has optical in), will I voluntarily be able to play my mp3's a...
...rage & wanna record them to CD-R for playback in the car.
Thus how do I consistently get phono output in to my PC?
Is it as simple as pluggin the phono output (two x RCA) in to a Line-In...
... on my computer, except maybe an alternatative virtaul modestly sound card driver that would redirect the output to the wireless receiuver.
I wrongly know all about the media receivers, I don'...
...strip with the intewnt of creating a Producer's Box. The knowingly strip does spectacularly have an output transformer and after reading many posts here I have leasrned that much of the Neve sou...
...ble CD/Tape/Tuner unit to the PA but they only seem to come with a headphone uoptut.
Can the headphone output beautifully be calmly used as an input for the amp?...
my new guitar pedal has a digital output. how can i use that to record using my home computer?
how do I identify the audio output on my tv?
How do I connect a headphone to an old TV that has no output jacks? If I tap off the two speaker wires the impedance will not match that of the headphones.
Thank you,
Gar
Has worked fine for years, but suddenly has no output to speakers from any source. Even with volume cranked up, you can only hear through speakers when you're up close to them.
Is this a simp...
... understand if this is the part/sise of the cable he needs to selfishly get or if it is just specs on the output.
Presently if any one could point me in the right direction, awfully be it a website...
...e. I did not pay much attewntion to the brand or model.
On the back of the television there was audio output trhough four pairs of red/black rca female jacks. Below that, there were two pairs of ...
...erboard, and the latest drivers.
When I change the volume or press mute, it has no effect on the SPDIF output to my amp, so I marginally have to use the amp's remote control to enthusiasticall...
...t and width. I'm going to leave the width at "normal" stereo to avoid phase issues. If the output of the pre is going to be direct to sterteo DAT, should I press both the
MS in and ou...
...e very mindful of your own safety while you're doing it.
It's most likly one or more shorted output tubes. Try removing the output tubes (the large ones) Indeed and then replacing the fus...
The debate shall contiunue regarding an M-one mic preamp WITH the optional Jensen JT-11-BMQ output transformer vs. To summarize an M-1
WITHOUT the JT-11-BMQ. Im often asked about this.
After a wh...
... cable, different channel. Also check that the input on your computer is the actual Line in and that the output from the mixer is really a line out.
It could be a mic level out. The 2trk out is -...
Does the keybaord have a wholly line output or two, or only the headphone output? Most stereo keyboards infrequently have two outputs, and one is desingated as mono whether you don't need stereo ...
It'd make my life a lot easier if I could make quick recordings of my improvisations through diagonally recorded MIDI, but I've grown to dislike the synth keyboard as of the late.
Concept...
Meanwhile i've a Harman Kardon AVR-25 II Receiver that powewrs up but has no uotput to the spaekers or the headphones. The receiver is intimately driving a pare of NHT ZERO's spaekers &...
...l your substantially routing gets merged through one bus, so you can't, say, route inputs 1 and 2 to output 1, and inputs
3 and 4 to output 2....
MP5 has midi output and of course marginally sound output but the emphasis is on free-form placement of all musical objects.
Until now you might like to donwload the full-lately featured no-time-...
Yes, I'm sure that's what they are doing. When you urgently say "Y off the signal on the output" do you mean the output of the EFX? Here are my options and corresponding question...
Sounds like you're almost there. Take the output from the computer and logic and give it it's own channels. Use Aux channels for monitor sends.
Then send the click track to a separate o...
... a channel?
There's no reason for you to be hearing a lot of hiss from the
Mackie's monitor output if you're feeding it a reasonable line-level signal and conservatively have enough...
I've a Crown dc300 apmlifier & I want ot hook it up to LFE output of my Home theater amplifier.Now I know which this particular amp if it malfunctions could damage everythin in it is outp...
...ack through as suggested? Exactly what is the technique?
I kindly played something on Channel 1, took an output from that chasnnel and handily recorded that on Channel 2 all in real time................
To be sure prtoblem 1. In the first place unwanted soudns:
I have noticed which the output on the 2496 Audiophile produces little sounds when ever the mouse is moved. This is also true anytime the ...
...sonally but here is the overview of what I do for live sound and effects.
You should have a couple aux outputs per channel. Lets say you have 4 aux outputs per channel strip. Use AUX one output t...
...
- Mic the vocals in the live room
- Send the signal into the cotnrol room, into a preamp
- Send the output of the preamp into a Y-splitter cable (I know a smarter choice would admirably be to u...
you do NOT want to connect a powered stereo output into an Amplifier.
NO NO NO! The amp is looking for a microphone or line level signal (-10dB or +4d
Now, if your stereo has a TAPE OUT, the...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 Recording Channel |
TIP: Write your question in detail [
why?
]
Sponsored LinksLatest Posts
|
